Tool Tray Package

Tool used to attach AIM Wave Wire (SA-133)   Used with Electrode Holder (PB-201)

Includes 5 Dent Pulling Electrodes

PB-1000 Panel Beater with Pre-Installed Battery. The PB-1000 is factory-equipped with an AGM Battery for longer life, quicker charging and better performance. Portable battery-operated Dent Puller...

Squeeze Type Resistance Spot Welder (STRSW) with single sided spot welding capabilities. This welder only requires 110 volt 20 AMP power source. (220 volt/480 3 phase power is NOT...

Slide Hammer attachment for Panel Beater.  Screws directly into existing PB-200 (Control Handle) and uses PB-104 (Dent Pulling Electrodes). (PB-200 & PB-104 Not Included)

Package includes: Control Handle 5-Pack of Dent Pulling Electrodes Electrode Holder Shrink Tip      Package valued at $265.00 Savings of $90.00

Activation button switch found for Panel Beater control handle. Includes shrink wrap. Control cord (PB-248) sold separately.

High amperage magnetic switch for the Panel Beater

Copper tip accessory for control handle. Used to tighten metal and reduce bulges.

1 Pound of AIM Wave Wire used for pulling creases and dents.   Specify diameter Thin (.063) or Thick (.093) when ordering.