Panel Beater Parts

1 Pound of AIM Wave Wire used for pulling creases and dents.   Specify diameter Thin (.063) or Thick (.093) when ordering.

1/2 lb of AIM Wave Wire used for pulling creases and dents.   Specify diameter Thin (.063) or Thick (.093) when ordering.

10-AMP Battery Charger (Internal Mount) and 15 AMP Thermal Breaker Included Fits Panel Beaters Built after December 1, 2017  

10-AMP Battery Charger (Internal Mount) and 15 AMP Thermal Breaker Includes Retrofit mounting bracket and accessories. Replaces discontinued item PB-210 (Minor modification to Panel Beater cabinet required for installation) Effective Sept 10,...

10 Foot Lead Set for Panel Beater with Control Handle Package   Includes: Control Handle Electrode Holder Copper Shrink Tool Dent Pulling Electrodes (pack of 5) 10 Foot Lead Set - (Positive Lead, Negative Lead, Control...

Lead Set for Panel Beater Includes Positive Lead, Negative Lead, Control Cord   *Control Handle NOT Included

15 amp breaker used in the model 1000 DX Charger(PB-211)

Control cable used to connect the  Control Handle push button (PB-226) to the Panel Beater.

5-AMP Battery Charger (Internal Mount) with enhanced heat sink and 10 AMP Thermal Breaker Included   THIS ITEM IS NO LONGER AVAILABLE (As of 1/1/2018). See Item PB-209A for Replacement   The item has been discontinued by our supplier...

Extra Strength 6 Finger Claw used with PB-244 AIM Slide Hammer

Use with AIM Wave Wire SA-133

Slide Hammer attachment for Panel Beater.  Screws directly into existing PB-200 (Control Handle) and uses PB-104 (Dent Pulling Electrodes). (PB-200 & PB-104 Not Included)