AIM Slide Hammer

Used to pull difficult dents.  Screws directly into your existing SA-109 (Quick Spot Handle) and uses the same dent pulling electrodes. Can only be used with models 1015, 1050 and 1250.

Includes 5 Dent Pulling Electrodes

Tool Tray Package Includes: Tool Tray 6 Finger Slide Hammer Claw Slide Hammer Wave Wire Tool 1lb AIM Wire   Package Valued at $397.50 if purchased separately

Package includes: Control Handle 5-Pack of Dent Pulling Electrodes Electrode Holder Shrink Tip      Package valued at $265.00 Savings of $90.00

1 Pound of AIM Wave Wire used for pulling creases and dents.   Specify diameter Thin (.063) or Thick (.093) when ordering.

The dent pulling control handle comes with a push button switch and 16 inches of  wire for attatching to existing control cord. (Does not come with electrodes, electrode holder, or shrink tip)

Package Includes: 6 Finger Slide Hammer Claw AIM Wave Wire Tool 1 Pound of AIM Wire  

Extra Strength 6 Finger Claw used with PB-244 AIM Slide Hammer

Tool used to attach AIM Wave Wire (SA-133)   Used with Electrode Holder (PB-201)

PB-1000 Panel Beater with Pre-Installed Battery. The PB-1000 is factory-equipped with an AGM Battery for longer life, quicker charging and better performance. Portable battery-operated Dent Puller...